Main /
Omniversal Cutting Frame
Overview
John Edwards wrote an article for the SOT Bulletin (noted below) about this. As John noted, this cutting frame is designed to address:
... how to increase the contrast of their patterns by using an HCF with the smallest possible radius.
In that article, John discusses how Walter Wenninga made a cutting frame to address this, and shows work produced on it. John also discussed some recommendations for changes to such a device should you choose to make one.
More Information
Published Articles
- The Omniversal Cutting Frame by John Edwards. The Society of Ornamental Turners Bulletin 144, Spring 2021, pg. 8
|
Disclaimer: eMail comments to me at OTBookOfKnowledge @ Gmail.com. The process of woodturning involves the use of tools, machinery and materials which could cause injury or be a health hazard unless proper precautions are taken, including the wearing of appropriate protective equipment. |